JKS MFG. Control Arm Relocation Bracket featuring Used To Relocate The Upper And Lower Control Arms. Part #: JKSJKS6201.
Features
Reduced Control Arm Angles Allow The Front Suspension To More Naturally Roll Over Bumps And Grooves In The Road
Corrects Caster For 2 Inch To 4-1/2 Inch Of Lift. The New Upper And Lower Control Arm Mounting Holes Are Precisely Positioned To Provide The Correct Caster At The Listed Lift Heights
The Upper Control Arm Mount Provides Two Hole Positions For Proper Caster Settings Through The Full Lift Height Range
Improves The Front Drive Shaft CV Joint Operating Angles Through Full Wheel Travel. The New Geometry Increases Clearance Between The Front Driveshaft And Exhaust At Full Suspension Droop
Brackets Are Made From Heavy-Duty 7GA Steel And Are Fully Boxed And Welded For Superior Strength When Compared To Bolt Together 2-Piece Designs
The Heavy Boxed Construction, Fully Gusseted Lower Mount And Welded Crush Sleeves Give You Extra Confidence Both On And Off Road
The Control Arm Correction Brackets Can Be Used With JKS Adjustable Control Arms For The Ultimate On And Off Road Performance
The Proper Mounting Locations For The Installed Lift Heights Are Outlined In The Installation Instructions
The Brackets Install Inside The Factory Upper And Lower Control Arm Mounts With The Factory Hardware
